![]() ![]() Make sure the X and Y motor is tightened in the motor mount, that the pulley (orange arrows in the picture below) is secured on the motor shaft and aligned with the pulley on the opposite end, and that the pulley can move freely. In general, Super-lube or any other multi-purpose grease will do as well. Another good lubricant is the Mogul LV 2-EP. According to our testers, the best lubricant is a homogeneous, soft grease with lithium additives, such as the GLEIT-µ HF 400. You can read more about in i3 Printer Regular Maintenance and this guide.Īlso, verify if the smooth rods don't bear any deep scratches and if the bearings are properly lubricated. See the photo below and make sure the cables are arranged accordingly. If the cables hit the frame before the extruder assembly does (if it's an MK3) or before the X end-stop does (if it's an MK2/S or an MK2.5) the printer detects an inaccurate end position. For example, there might be a piece of filament stuck around the belt (usually around the Y-axis pulley) from your previous prints.Īnother instance of obstruction is when the zip ties or another part of the extruder cable bundle are not arranged according to 5. Make sure there are no obstructions in the path of the extruder or heatbed and their bearings. Make sure the extruder and the heatbed can move freely Also, note that in Stealth mode, the Crash detection feature is not available. For bigger or more complex prints, the Normal mode is recommended. The stealth mode is perfect for small and simple objects. You can change Power mode in the LCD Menu -> Settings -> Mode. Run the printer in Normal mode rather than in the Stealth mode. Prusa i3-series Check your printer’s power mode ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |